![]() inf file, if it is needed here:ĬlassGUID= There's another such post at a Vista64 forum, but there is no answer there: I ran a CRC check for the drivers I have on my hard disk with the ones I downloaded, and they are the same. ![]() I've tried searching the net for drivers, but what I did found was the same stuff that I've got. When I tried to install it in Vista, the computer did not stop responding, but it gave a message that the required software could not be installed, and the reason it gave was "The required line was not found in the INF". Each time, the computer stops responding and I have press the reset button. I've tried allowing it to automatically install the driver, I've tried pointing out the folder manually from the hard disk where I have copied it and the CD, and I've tried allowing it to connect to the net to find a driver, but nothing works. ![]() ![]() At present, when I try to install it, the Power Voice software easily installs, then when I connect the audio recorder by way of USB, XP gives the messages of found new hardware and the driver installation starts, but then the computer stops responding at the point where it shows files being copied between two folders. I have used this device earlier and it has worked. The installation CD has the setup, which installs Power Voice II onto the computer there's also a folder called "Driver" which contains two files: CenixFMC.inf (3KB) and CenixFMC.sys (19KB). There's an audio recording device I use, called Cenix Digital Voice Recorder.
0 Comments
Leave a Reply. |